In this guide: How it works · DAF or clarifier · When to use it · When not to · The complete line
A DAF (dissolved air flotation) unit separates light solids, grease and oils from water by floating them with air microbubbles, instead of waiting for them to settle. It is the reference equipment for effluents with a high grease load: meat processing, dairy, food, fish processing and oil.
How it works
- Chemical conditioning. Coagulant and flocculant are dosed so that fine particles and emulsified grease form flocs.
- Microbubble generation. Part of the treated water is recirculated, pressurized and saturated with air. When it is released into the tank at atmospheric pressure, the air comes out of solution as very fine bubbles.
- Flotation. The microbubbles attach to the flocs and carry them to the surface, where they form a layer of floating sludge.
- Separation. A surface skimmer removes the floated sludge and the clarified water exits from below. Heavy solids that do not float are purged from the bottom.
The result is the removal of suspended solids, grease and oils, and the insoluble fraction of the COD.
DAF or clarifier
| Criterion | DAF | Conventional clarifier |
| Solids it separates best | Light solids, grease, oils, fragile flocs | Heavy solids that settle well |
| Retention time | Minutes | Hours |
| Footprint | Smaller | Larger |
| Sludge produced | More concentrated | More dilute |
| Energy use | Compressor and recirculation pump | Minimal |
| Chemicals | Almost always needed | Depending on the case |
When to use it
- Effluents with grease and oils: meat processing, slaughterhouses, dairy, edible oil plants, fish processing and refineries. A clarifier does not retain them because they float.
- Pretreatment ahead of a biological process: it lowers the COD and grease load reaching the reactor, protects fine bubble diffusers from fouling and stabilizes the process.
- Limited space: a compact DAF does the job in a fraction of a clarifier’s footprint.
- Water reuse or final polishing: when clarified water with low solids content is needed.
When not to
If the effluent carries sand or heavy mineral solids, a grit chamber is needed first. Nor does it replace biological treatment: it removes what is suspended or emulsified, not dissolved COD.
The complete line
A DAF performs best when what goes in is well prepared and what comes out has somewhere to go:
- Before: a self-cleaning rotary drum screen removes coarse solids, hair and fibers that would otherwise float with the sludge. To choose the screen, see our screening guide.
- During: metering pumps dose coagulant and flocculant in the right proportion.
- After: the floated sludge, rich in grease, is dewatered. The screw press is a common choice for this type of sludge; the alternatives are covered in our sludge dewatering guide.
See our compact dissolved air flotation system or tell us about your effluent and we will assess whether a DAF is the right solution.


