In this guide: How each one works · Quick comparison · When to use each one · Three questions before deciding
In many plants, sludge dewatering is the stage that weighs most on operating cost: every point of moisture left in the cake is paid for later in transport and final disposal. The three most widely used machines for this task are the plate filter press, the screw press and the belt filter press. All three separate solids from water, but they do it on different principles, and that defines where each one performs best.
How each one works
Plate filter press. Sludge is pumped under pressure between plates covered with filter cloths. Water passes through the cloth and the solids are retained, forming the cake. It works in cycles (filling, filtration, opening and discharge) and delivers the driest cake of the three. Membrane plates add a squeezing stage with air or water that reduces moisture even further. Learn more in our guide What is a filter press and how does it work.
Screw press. A screw pushes the sludge through a stack of fixed and moving rings. The gap between rings narrows along the unit, building internal pressure that thickens and dewaters the sludge. It runs continuously at low speed, and the movement of the rings keeps the filter clean.
Belt filter press. Flocculated sludge first drains by gravity on a belt and is then squeezed between two belts running over rollers of decreasing diameter. Pressure and shear increase at each roller. It is a continuous, high-capacity machine that can be combined with a belt or drum thickener in the same unit.
Quick comparison
| Criterion | Plate filter press | Screw press | Belt filter press |
| Operation | Batch cycles | Continuous | Continuous |
| Cake dryness | Highest | Medium | Medium |
| Operator attention | Medium; lower if automated | Low | Medium |
| Wash water | Only periodic cloth washing | Low | High, continuous belt washing |
| Energy use | Medium (pressure pumping) | Very low | Low |
| Footprint | Larger | Compact | Medium |
| Odors and splashing | Contained (closed unit) | Contained | More exposure |
When to use each one
Filter press, when cake dryness is the priority: mineral or inorganic sludge, mining, ceramics, chemicals, or plants where disposal cost per tonne is high. Also when the filtrate must be very clean. It can be almost fully automated: plate shifting, cloth washing and quick opening.
Screw press, when continuous operation with minimal supervision is the goal: small and medium plants, food processing, dairy, meat processing and biological sludge with grease. Its low energy and wash water use make it attractive where there is no staff dedicated to dewatering.
Belt filter press, when sludge flows are high and continuous capacity is needed at a moderate capital cost: municipal plants, pulp and paper, tanneries and textiles. EKOSEP® belt filter presses handle 2 to 190 m³/h of sludge, with feed concentrations of 0.1 to 9 % solids depending on the model, and deliver a cake of up to 30 % solids.
Three questions before deciding
- How much does it cost to dispose of a tonne of sludge? If it is expensive, the extra dryness of the filter press usually pays back its higher investment.
- Is an operator available on every shift? If not, the screw press is the most autonomous option.
- What are the sludge flow and concentration? With large volumes of dilute sludge, a belt filter press with integrated thickener handles thickening and dewatering in a single unit.
In all three cases, correct polymer dosing matters as much as the machine. An automatic polymer preparation and dosing system ensures stable flocculation and avoids overdosing. To feed the unit, progressive cavity pumps move thickened sludge without breaking the floc.
Not sure which one suits your plant? Send us your sludge data (flow, concentration and origin) and we will recommend the right equipment.


